Tuesday, 21 February 2012

Part 1 - Anemometer 3D Max

Here is my first model i have created out of my three i have chosen to go with this model because this one gained my interest. To create this i had to use a number of shapes for the base placing them on top of one another then aligning making sure they were put in place. I then created the main pole and three attached sticking from the sides. The next part was the three parts which go on the end of the poles. In order to make these look how they should i had to make the an editable poly which i then simply indented them to make them half semi circles. My 3D Max model is shown below.



I am now up to adding the material to the model. 




No comments:

Post a Comment